If you are like an individual who wants to perform a garage door repair project with at least a mild sense of expertise and technical awareness. Since a garage door is a large and complicated equipment which can be hard to manage. However, the fear is not warranted if this risky job can handle using few manageable procedures. Click here to learn more useful tips, tricks, and instructions regarding the garage door repair project.
Actually, the mechanism of the garage door is not simple. There are two types of garage doors. The first type is where the garage door is made from a single solid panel that goes up on metal tracks. The second important type of garage door also rolls up on metal tracks but created in multiple sections. If you have installed a metal garage door that runs on metal tracks and stored into a horizontal cylinder above the garage door opening, then call a professional garage door expert. This type of garage door is complicated to fix without proper training and equipment.
While conducting garage door repair on your own, the first important task is to inspect the garage door tracks. They can accumulate a lot of dirt, dust, hardened grease, and a piece of dried leaves that might stick to the garage door. These tracks should be cleaned and lubricated to remove the solid mess. All greasy materials can become a solid and sticky obstruct. The garage door rollers that can place inside the tracks can become rusted or worn out. Wash garage door tracks using any mild washing liquid and then wipe them with a towel. Once they are cleaned, use any high-quality silicon spray, household oil, or powdered graphite to lubricate them.
Another common issue is misaligned or imbalanced garage door tracks. Dented or bent tracks should be straightened using a rubber mallet. Make sure that the tracks are parallel to each other and perpendicular to the front wall of the garage. Badly damaged garage door tracks should be replaced with new ones.
Since a garage door is a weighted and bulky device, garage door torsion springs are used to counterbalance the weight of the garage door. These springs are placed on either side of the garage door or above the garage door’s opening. When the garage door is closed properly, these springs are stretched to their maximum tension which can be dangerous to handle.
Over time, garage door springs may lose their strength or break down. If you experience that your garage door is hard to operate then you need to readjust them. This task can be performed using an adjustable plate that is attached to springs. If you have a sectional garage door then the springs are attached with a metal cable which needs to be adjusted to maintain their tension. To perform garage door repair safely, it is advisable to seek the services of professional garage door technicians. Taking in mind the strength and tension of springs and the complication of the mechanism involved, you need to consult an expert on the side of safety if the given solution is not clear.